OBD2 code reader TOPDON Artilink200 supports reading and clearing codes stored in vehicle ECU about partial Engine and Transmission faults.
I/M readiness status checking works on the sensors related to emissions, checking the sensorsrsquo running status to figure out whether your vehicle pass the emission test or itrsquos time to have your vehicle maintenance.
Freeze frame data retrieving checks the certain vehicle conditions which are recorded by the on-board computer at the time the emission-related fault occurs, and vehicle identification number retrieving helps users identify vehicle information.
Suitable for most 1996 US-based, 2000 EU-based and newer vehicles that is equipped with 16pin port and is compliance with OBD2/CAN protocols.
Shows the detailed description of the current Diagnostic Trouble Code (DTC), retrieve generic (P0, P2, P3, and U0), manufacturer specific (P1, P3, and U1) codes and pending codes.
Erasing codes: turns off check engine light (MIL), clears codes and resets monitors.
Equipped with a 105cm (41.34 inches) connecting cable.
Unlike other lower-leveled versions, it supports ALL OBD2 protocols, including K Line, L Line, Double CAN, J1850 PWM, and J1850 VPW Communication Protocols.
No any Batteries or Charger needed to power the code reader on, you can directly use it with power from the OBDII Data Link Connector in your vehicle.
1019 - AE32881119112
Kommentarer (0)
Ingen kundeanmeldelser enda.
Din tilbakemelding på anmeldelsen kan ikke sendes inn
Rapporter kommentar
Er du sikker på at du vil rapportere denne kommentaren?
Rapporten er sendt
Din kommentar er sendt inn og vil bli vurdert av en moderator.
Din rapport kunne ikke sendes inn
Skriv din omtale
Anmeldelse sendt inn
Kommentaren din har blitt lagt til, og vil være tilgjengelig når den har blitt godkjent av en moderator.